The same phenomenon takes place when the radar frequency changes because the relative position of the target scatterers, measured at different wavelengths, changes. As the geometry of the target’s scattering points changes aspect with motion, the target’s RCS varies, or scintillates. The RCS of a complex target, such as a ship or aircraft, depends on the look angle of the radar. The trihedral corner reflector is made with three right angle plates, which is illustrated in the figure below. Trihedral Reflector’s RCS, Edge length and Frequency Correlation If the trihedral is placed such that the bottom plate is parallel to the ground, then the RCS of the trihedral is severely diminished at low grazing angles with respect to the ground.If a trihedral is tilted forward so that its direction of maximum RCS is at a shallow grazing angle with respect to the ground, then ground-lobing becomes problematic, diminishing the accuracy of the RCS calculations.The RCS falls off rather dramatically as aspect angles approach parallel with the plates that make up the reflector.The equations often provided for theoretical RCS assume the trihedral exists in free space, independent of surrounding environmental reflectors such as the ground.However, the following undesirable attributes also exist. The wider half-power response of the triangular reflector, the more leeway there will be for alignment between the radar and the calibration target. They are physically smaller and yield a wider half-power response.The trihedral corner reflect is highly tolerant to the misalignment, which offers a convenient way for quick field setup.Theoretical RCS easily calculated as a function of aspect angle.Fairly broad range of aspect angles with a large RCS.Fairly large Radar Cross Section (RCS) for its size.They offer the following desirable attributes. Trihedral corner reflectors are a canonical radar reflector frequently used to calibrate or gauge the performance of radar systems. Trihedral corner reflectors are the preferred canonical target for SAR performance evaluation for many radar developments programs. The larger a corner reflector is, the more energy is reflected. Thus, even small objects with small RCS yield a sufficiently strong echo. Incoming electromagnetic waves are backscattered by multiple reflection accurately in that direction from which they come. A corner reflector consisting of two or three electrically conductive surfaces which are mounted crosswise (at an angle of exactly 90 degrees). Corner reflectors are used to generate a particularly strong radar echo from objects that would otherwise have only very low effective Radar cross section (RCS). The commonly seen corner reflectors are dihedral and trihedral. In general, the corner reflector consists mutually intersected perpendicular plates. Therefore, corner reflector is a useful device for Radar system calibration. A corner reflector is a passive device used to reflect radio waves back toward the emission source directly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |